Garage Door Spring

However, if you decide to do it yourself, here are some general steps:

Gather the necessary tools:

1. You will need a winding bar, a socket wrench, a tape measure, and a new garage door spring that matches the specifications of your old one.
2. Release the tension on the old spring
3. Use the winding bar to loosen the tension on the old spring.
4. Insert the winding bar into one of the holes on the winding cone, and turn it counterclockwise until the tension is released.
5. Remove the old spring: Once the tension is released, use a socket wrench to remove the set screws on the old spring. Slide the spring of the shaft and set it aside.
6. Install the new spring: Slide the new spring onto the shaft and secure it in place with the set screws. Make sure the spring is centered on the shaft.
7. Wind the new spring: Use the winding bar to wind the new spring in the opposite direction of the old spring. Insert the winding bar into one of the holes on the winding cone, and turn it clockwise until the spring is wound tightly.
8.  Test the tension: Use the tape measure to measure the length of the spring. The length of the new spring should be slightly shorter than the old spring, as it will stretch over time.

Test the tension by opening and closing the garage door a few times to make sure it is working properly.

It is important to note that if you are not experienced with garage door spring replacement, it is best to hire a professional.

Garage door springs are under a significant amount of tension and can cause serious injury or even death if not handled properly.

Garage door springs are a critical component of your garage door system. They provide the necessary tension to lift and lower the door smoothly and safely.

However, over time, garage door springs can wear out, break, or lose tension, causing the door to become heavy, difficult to open, or even dangerous.

In this article, we will discuss what you need to know about garage door spring replacement.

Signs of Garage Door Spring Failure:

Before we dive into the replacement process, it’s important to know the signs of garage door spring failure.

These may include:

• The door feels heavy or difficult to open

• The door slams shut or close too quickly

• The door only opens a few inches before stopping

• The door makes a loud bang or popping sound when opening or closing

• The springs appear stretched, damaged, or worn out

If you notice any of these signs, it’s important to have your garage door springs inspected and replaced as soon as possible to prevent further damage or injury.

Types of Garage Door Springs:

There are two types of garage door springs: torsion springs and extension springs. Torsion springs are located above the door, while extension springs are located on either side of the door.

Torsion springs are typically more durable and longer-lasting than extension springs, but both types can wear out over time.

Garage Door Spring Replacement Process

Garage door spring replacement is a complex and potentially dangerous process that should only be performed by a trained and experienced professional. Here are the general steps involved in garage door spring replacement:

1. Identify the type and size of the spring needed for your door

2. Disengage the opener and release the tension on the springs.

3. Remove the old springs and install the new springs.

4. Wind the new springs to the correct tension.

5. Reattach the opener and test the door’s operation.

  It’s important to note that garage door spring replacement is not a DIY project. Attempting to replace the springs yourself can result in serious injury or damage to your property. Always hire a professional garage door technician to perform spring replacement and any other garage door repairs. Cost of Garage Door Spring Replacement The cost of garage door spring replacement can vary depending on the type and size of the springs, as well as the complexity of the installation.  

Garage door spring replacement is an important maintenance task that should be performed by a professional technician.

If you notice any signs of a spring failure, contact a garage door repair company to inspect and replace the springs as soon as possible. With proper maintenance and care, your garage door springs can provide years of reliable service.